AXAIM020-01 (AUTO-48) 3/03 Page 3 of 16
© 2003, Flowserve Corporation, Printed in U.S.A.
BUSwitch
™
with FOUNDATION
®
Fieldbus Protocol
Installation, Operating and Maintenance Instructions
Flowserve Corporation 1350 N. Mountain Springs Parkway 1978 Foreman Dr.
Flow Control Division Springville, Utah 84663-3004 Cookeville, TN 38501
www.flowserve.com Phone: 801 489 8611 Phone: 931 432 4021
Start-up Guide
CAUTION
The BUSwitch
™
may cycle during a configura-
tion download. Exercise caution in handling
valves that may be stroked during these
procedures.
For best results, Flowserve strongly recom-
mends reading this entire document before
attempting to configure and commission
BUSwitches.
1 Following the instructions in “Mechanical
Installation,” install the BUSwitch
™
onto a
pneumatic actuator and turn supply air on.
2. Following the instructions in “Electrical connec-
tions,” connect fieldbus and optional dry-contact
wiring.
3. Referring to control system or configuration system
documentation, install BUSwitch
™
device descrip-
tion (DD) files onto system hard drive. Note:
Readme file on DD floppy contains instructions.
Note: For Fisher DeltaV systems, the DD files
must be copied to a directory or folder named
“464C4F” in order for the system to find them.
4. Initialize communications with device and bring
up the “Live List.” BUSwitches have been
configured from the factory with an ID of
“464C4F5053:BUSWITCH: [serialnumber]” and
a default tag of “FLOWSERVE BUSWITCH.”
Note the serial number.
5. Change the BUSwitch
™
attribute Device ID to the
value noted in step 4 and change the Device Tag
to the appropriate value.
6. Assign the Tag configuration in step 5.
7. BUSwitches are shipped with resource block,
transducer block, (2) DO blocks and (2) DI blocks
pre-configured unless specially configured by
agreement with customer. Refer to the appropriate
sections in this manual for the default configuration.
Make any desired changes to this configuration
and download.
supplied to the interface card.
Max. length of 32 characters.
.
Commentaires sur ces manuels