Flowserve MW-200 Series Manuel d'utilisateur télécharger pdf

Installation

Instructions

Durametallic

MW-200 Series

Liquid Lubricated Dual Cartridge

Canister Seal for Mixers and Agitators

Experience In Motion

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - Instructions

Installation InstructionsDurametallic® MW-200 SeriesLiquid Lubricated Dual CartridgeCanister Seal for Mixers and AgitatorsExperience In Motion

Page 2 - 1 Equipment Check

21 Equipment Check1.1 Follow plant safety regulations prior to equipment disassembly: • Consult the plant Material Safety Data Sheet (MSDS) les for

Page 3 - Figure 1

31.10 Pressure testing of this cartridge canister dual seal prior to installation is possible using ltered dry nitrogen or instrument air. Cons

Page 4 - 2 MW-200 Seal Installation

42 MW-200 Seal InstallationTools needed: Tools provided: • Lubricant for O-rings and equipment shaft OD. Tools not provided:

Page 5 - 4 MW-200 Seal Piping

52.6 Reinstall the shaft coupling and/or drive. Remove any shaft holding or restraining clamps and complete adjustments so that the shaft is in i

Page 6 - Plan 54 - Forced Circulation

6Recommended Piping for Dual Liquid Lubricated SealsPlan 53A - Induced Circulation (high shaft speeds)Figure 2Plan 54 - Forced CirculationBufferOutlet

Page 7 - 5 Seal Operation

75 Seal OperationTo assure reliable operation of this sealing product, the following operating guidelines should be observed.5.1 Maintain the liquid

Page 8 - TO REORDER REFER TO

ﬂowserve.comTO REORDER REFER TOB/M #F.O.To ﬁnd your local Flowserve representativeand ﬁnd out more about Flowserve Corporation, visit www.ﬂowserve.com