Installation InstructionsExperience In MotionCircpac MDSplit Segmented Circumferential Gas Seal
1 Equipment Check and Seal Preparation1.1 Refer to Figure 1 for sleeve/shaft and equipment requirements.1.2 The equipment sleeve/shaft must be clea
32 Seal Installation (Split Housing Designs)Seal components are assembled in the following order: housing gasket (if separate), bottom housing half,
4Figure 62.5 Select a ring segment that does not havethedrivepin.Positionitoverthegroove in the lower housing half. Make sure the numbered si
52.9 Rotate the ring assembly until the drive pin engages the pin slot at the housing joint. 2.10 Repeat steps 2.3-2.9 with all segmented rings. Fi
62.13 Center the housing assembly on the shaft as required. If centering devices are used, release any housing supports so that the centering devices
7 3 Seal Installation (Non-split Housing Designs) 3.1 Circpac MD seals with non-split housings are pre-assembled at the factory for cartridge inst
TO REORDER REFER TOB/M #F.O.FIS153eng REV 01/03 Printed in USAflowserve.comTo find your local Flowserve representativeand find out more about Flowserve C
Commentaires sur ces manuels