Flowserve PSS II Durametallic Manuel d'utilisateur télécharger pdf (Page 3)

Tools Needed for Installation

•

" and

" or

" T-handle hex key wrenches (supplied with seal)

 • Anopenendwrenchfortheglandbolts.

 • Acommonscrewdrivertoremovethesettingdevicesandcentering 

devices.

Installation

Step 1 Lubricate the exposed surfaces of the sleeve gasket and sleeve gasket

ends, rotating face gasket ends, and seal drive split joint gaskets with

the enclosed lube.

Step 2 Loosely assemble the seal drive halves around the shaft and slide the

seal drive towards the box until the setting devices contact the box face.

Step 3a With the seal drive still loose, align the rotating face joints so there is no

step at the joints

Step 2Step 1

b Finish tightening the seal drive cap

screws to approximately 40 in-lbs.

Recheck the rotating face joints

  foratness.Asmallmismatch

can be corrected by pushing on

the high side of the joint or gently

prying on the low side.

 c Therotatingfacejointsmustbeat

  andsmooth.Anymismatchwillresult

in leakage. If a mismatch exists,

loosen the seal drive cap screws 1-2

turns and repeat steps a and b.

d Clean rotating face with alcohol.

Caution: Consult material safety data sheets for proper handling of alcohol.

Step 3

1 2 3 4 5 6 7 8

Pas de commentaire

Flowserve PSS II Durametallic Manuel d'utilisateur Page 3