Flowserve URB 1 Manuel d'utilisateur télécharger pdf (Page 19)

Basic Settings – continued –

Setting /changing node IDs of bus-based equipment

The standard default node ID setting of all

bus devices that can be displayed is “O

FF”.

This setting acts as a wild card for all bus

devices which are not displayed with the

URB 1.

For each bus device that shall be displayed

by the URB 1 a node ID has to be

established manually.

We recommend to accept the factory set

node IDs of GESTRA bus devices. For the

relevant node ID setting please refer to the

corresponding installation manual of the

device.

Press button briefly to show the

address list and activate the

parameterisation mode.

Press button briefly to activate the line

selection mode.

briefly

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

Pas de commentaire

Flowserve URB 1 Manuel d'utilisateur Page 19