Flowserve SPECTORcontrol Manuel d'utilisateur télécharger pdf (Page 14)

Commissioning – continued –

Remote monitoring

SPECTORcontrol allows remote monitoring and operation via PC. For this purpose a

browser (Internet Explorer 5.5 or higher) must be installed as frontend. You can also use

a handheld PC.

There are two ways to establish a connection:

1. A direct connection to the network/Intranet can be implemented via the integrated

Ethernet interface using a patch cable (RJ45).

Or, alternatively, the connection can be established via Hub/switch.

2. An analog modem can be connected to the serial interface COM3 (RS232). In this

case the connection will be directly established, e. g. via Internet.

The following device has been tried and tested by GESTRA:

■ devolo-Microlink 56k Fun II serial

The IP address of SPECTORcontrol can be obtained from your system or network

administrator. The IP address must be uniquely defined in the network.

Integration of third-party equipment

Third-party equipment such as Profibus and MODBus can - after prior consultation with

GESTRA - be directly connected to SPECTORcontrol.

Using the help function

You find the help function of the screen mask in the top right corner of the menu bar.

When you press the button with the question mark a new window will pop up, giving

additional information on the current screen mask. The window is closed by the user.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Pas de commentaire

Flowserve SPECTORcontrol Manuel d'utilisateur Page 14